USB Drive attached with this computer has malfunctioned

Usb Not Recognized In Windows - The best way to Fix Or Repair Usb Not Recognized In Windows, Problem Of Acer Laptop Brand and Model: Acer Aspire 3640 Problem: This laptop started in with all the following complaint: Whenever any USB devices is connected therein laptop. Could possibly Windows error which will turn up and says that USB Not Recognized (one of several USB Drive attached with this computer has malfunctioned, and windows isn't going to recognize it. For assistance in solving this matter, click this message). Diagnosis, Cause and Remedy: When a USB is inserted into this laptop this error belly out: Usb Not Recognized (among the USB devices mounted on this computer has malfunctioned, and windows isn't going to recognize it. For help in solving this matter, click this message). One reason behind this problem is the driver with the USB controller gets corrupted. First thing I did so was updating the driving force for the USB controller. After updating the driving force, the issue remain. When the previous method, cannot solved the big mistake, it is advisable to repair or reinstall the Windows Operating System because sometimes the O. S. (Operating-system) gets corrupted due to viruses or a few other reasons.
After i finished repairing the O. S., I started up laptops over again and unluckily the issue didn't gone away. Believing that the corrupted system cannot be restored through repairing the OS, the 2nd step I did was i always reformatted this laptop hoping it may be restore. After reformatting laptops and installing the respective drivers with the peripheral devices, still no luck, because the error was not eliminated. I told myself "this can't be" usually when you reformatted the Windows based pc, all will probably be back to normal, in this example it didn't. I now suspect hardware problem on the laptop, Therefore i thought we would disassemble laptops and free the motherboard from all dust, as what I've said on these articles, that this dust can also be one factor which in turn causes the motherboard electronic components to get shorted. Because when dust gets thick it is going to be a conductor. After disassembling internet connected computers and obtained the many dust. I tested the voltage for the terminal on the USB port. The normal supply voltage to the USB Flash Drive if it is working fine is 5v DC enough to switch on USB devices. The voltage is normal after I tested it, This matter is a touch bit harder because I've already done several possible solutions i usually employed to solve this sort of problem. After doing all the previous steps whilst still being not fixed the problem, I stopped for awhile and further analyze what's really causes the condition.
Upon thinking, It came to my thoughts that imagine the flow of current about the USB port that's generated through the supply voltage is already deteriorated. For ones information get the job done power voltage is merely normal, say 5 volts DC, nevertheless the current (measured in amperes) is deteriorated, still It wouldn't supply enough power to make the USB devices work. The last method I've designed to solve this issue was i used another USB hub 2.0 and that is inserted from one on the laptop's USB port. After installing the USB hub 2.0 and whenever I connect any USB Flash Disk, it already works perfectly fine plus the USB Not Recognized problem was completely eliminated. Hope this post helped you obtain some ideas about solving USB Not Recognized symptom in Windows. Did you find this informative article helpful? Should you did, chances are you'll look at the link below have a look at: http://podnutz-hdlaptoprepairvideos.blogspot.com/